Tuesday, January 3, 2017

Balloon Adventure Pop- Up Birthday Card - Card 3

This is the 3rd card made using the Balloon Adventure stamp set and coordinating framelits/die.
This card features a pop up center.

Above is the card front.
The basic card is Pacific Point card stock. layered with Very Vanilla, and a 4 by 2 3/4" piece of Animal Party DSP.
The sentiment is stamped with Pacific Point ink on a 2 1/4 by 3 1/2" piece of Very Vanilla cardstock, which was matted with a 2 1/2 by 3 3/4" piece of Pacific Point card stock.  This unit was adhered to the card front with dimensionals.
Three balloons - one each of Emerald Envy, Crushed Curry, and Pacific Point card stock, were punched with the Balloon Builder punch and adhered randomly to the card front with dimensionals.

On the inside of the card is the Pop up mechanism.  This is made using the Balloon pop up die which is laid on the center line of a 5 1/2 by 7 1/2" piece of Very Vanilla card stock and run through the Big Shot.

Before adhering the die cut to the card front, the balloons were stamped - first with the solid stamp and secondly with the polka dot stamp - in the following colours:  Crushed Curry, Pacific Point, and Tangerine Tango.  The sentiment is stamped with Pacific Point. A small bow was die cut in Pacific Point and adhered over the bow at the bottom.

A 1/2 by 5" piece of DSP was adhered over the ends of the Very Vanilla cardstock.

Here the card is completely opened.

Supplies Used:
Stamps: Balloon Adventure
Inks: Pacific Point, Crushed Curry, Tangerine Tango
Papers: Pacific Point, Very Vanilla, Party Animal DSP, Crushed Curry, Emerald Envy
Accessories: Balloon Pop up Thinlet/dies, Balloon Builder punch, dimensionals.




No comments: